USE A FLEXIBLE TAPE
Use a soft tailor's measuring tape rather than a rigid ruler.
WILDSOUL STUDIO · COMMISSION RESOURCES
FURSUIT MEASUREMENT GUIDE
MEASURE WITH CONFIDENCE
Learn how to take accurate fursuit measurements for your head, neck, paws, and tail so your custom pieces can be built for a comfortable fit.
This guide walks through the measurements WildSoul Studio may request for your commission. You do not need to provide final measurements before submitting a commission request.
01
BEFORE YOU MEASURE
Use a flexible measuring tape and wear light, close-fitting clothing while measuring. Keep the tape comfortably against the body without pulling it tight or leaving excessive slack.
KEEP A NATURAL POSTURE
Stand naturally and avoid deliberately stretching or tightening your body.
ASK SOMEONE TO HELP
For measurements that are difficult to take accurately yourself, ask another person to assist.
MEASURE TWICE
Take every measurement at least twice. If the results differ, measure again before submitting.
USE ONE UNIT CONSISTENTLY
Centimeters or inches are both acceptable, but clearly state which unit you are using and do not mix them.
02
HEAD MEASUREMENTS
To measure your head for a fursuit, use a soft measuring tape to record your head circumference, head height, and neck circumference. Keep the tape comfortably close without pulling it tight, and follow the steps below for each measurement.
Interested in this commission type? Explore our Custom Fursuit Heads.
A. HEAD CIRCUMFERENCE
Wrap the measuring tape around the widest part of your head, passing above the eyebrows, above the ears, and around the fullest part at the back of the head.
Tip: Keep the tape level and comfortably snug. Do not pull it tight enough to compress the hair or skin.
B. HEAD HEIGHT
Measure vertically from the top of your head down to the bottom of your chin.
Tip: Keep your head in a natural, level position and measure in a straight vertical line.
C. NECK CIRCUMFERENCE
Wrap the tape around the base of your neck where the fursuit head or neck area will naturally sit.
Tip: Keep the tape comfortably snug without tightening it around the neck.
03
PAW MEASUREMENTS
These measurements are only required if your commission includes paws. We will let you know when they are needed.
If paws are part of your approved commission configuration, explore our Partial Fursuit commissions.
A. ARM CIRCUMFERENCE
Measure around the fullest part of your arm while keeping your arm and muscles relaxed.
Tip: Keep the tape comfortably against the arm without pulling it tight.
B. PALM WIDTH
Keep your hand relaxed and fingers naturally together. Measure straight across the widest part of your palm, excluding the thumb.
Tip: Do not spread your fingers while taking this measurement.
04
TAIL LENGTH
WildSoul Studio tails are approximately 1 meter (about 39 inches) in length by default unless otherwise discussed as part of your commission.
If your character design requires a shorter, longer, or unusually shaped tail, let us know during the commission process. We will confirm the appropriate dimensions with you before production.
05
HOW TO SUBMIT YOUR MEASUREMENTS
Once your commission reaches the measurement stage, WildSoul Studio will contact you with a measurement request.
Reply using the instructions provided in your commission email and clearly label each measurement with its unit.
If your commission includes paws and an Arm Circumference measurement is requested, include that measurement as well.
PLEASE DO NOT ESTIMATE YOUR MEASUREMENTS.
EXAMPLE
Head Circumference: 58 cm
Head Height: 24 cm
Neck Circumference: 38 cm
Palm Width: 9 cm
COMMON MEASUREMENT MISTAKES
PULLING THE TAPE TOO TIGHT
This can result in measurements that are smaller than your actual size.
LEAVING TOO MUCH SLACK
Loose measurements can affect the intended fit.
MIXING UNITS
Do not switch between inches and centimeters without clearly labeling them.
ESTIMATING INSTEAD OF MEASURING
Always use an actual measuring tape rather than relying on clothing sizes or estimates.
FAQ
Do I need measurements before requesting a commission?
No. You can submit your commission request and receive your quote before providing final measurements. We will request measurements at the appropriate stage of your commission.
How do I measure my head for a fursuit?
Use a soft measuring tape to record your head circumference, head height, and neck circumference. Keep the tape comfortably close without pulling it tight, and repeat each measurement to confirm it before submitting your final numbers.
Should I use inches or centimeters?
Either is acceptable. Please use one unit consistently and clearly label the unit when submitting your measurements.
What if I get two different measurements?
Measure the area again. We recommend taking each measurement at least twice and submitting the result you can reproduce consistently.
What if my measurements change before production begins?
Contact WildSoul Studio before production begins and provide your updated measurements. We may ask you to reconfirm important measurements when your production slot approaches.
YOUR CHARACTER · YOUR JOURNEY
READY TO BRING YOUR CHARACTER TO LIFE?
Start with your character concept and commission details. We'll guide you through measurements when the time comes.